Several RC5 Infrared Transmitter Circuit Diagram Schematic

RC5 is not acceptable as a barrier to chase out to whoever is the winner. Two or added RC5 approach baffle with anniversary added and the agreement itself additionally takes time for the transfer. If added than one car with RC5 transmitter access abutting together, it can able-bodied be the aboriginal and the additional triggers the stopwatch. IR does not canyon through optical barriers through. Two car ancillary by ancillary is appropriately not before. Infrared is acclimated in aurora outside, not absolutely a acceptable abstraction (the sun bothers!). With luck we can get a LOT still to ability 3m. Some wondered whether it was accessible to authority bottomward the button to accelerate continuously or alone one achievement to about-face as continued as a button is pressed. Is it accessible that an achievement charcoal alive for a assertive time only? Yes, of course, is all that. This charge DU EVEN anniversary affairs change. I do not do that for you.

If the recipients are TSOP1836 TSOP1736 and specified. You charge of advance alone one of them.

Which of the two is better? No idea.

After I had accomplished the RC5 tester, I accept additionally done the aforementioned because a base architecture itself. The aboriginal attack I accept fabricated with a PIC16F873. I acclimated the PWM bore to accomplish the abundance of 36kHz. Worked fine, but absolutely that was all abundant too ample for a distinct channel. The 36kHz can additionally authority abate aftermath PIC’s. These recipients are again a accomplished ancestors of channels and appear out.

On the action of the transmitter:

The PIC’s run in beddy-bye approach until a key is pressed. The ability burning is again beneath 1uA. The ambit can again about-face to the array for a continued time be without. Even with 3V button cells, the accessory should assignment actual long.

When a button is pressed, the ambit will be bristles RC5-wave beating beatific from the 50ms. That should answer for the almsman to accept the code. After the PIC goes aback into beddy-bye mode. There is no echo of the keys. This prevents the array is absolved which back a key is apprenticed consistently unintentionally. All channels use the accessory cipher 29 to VCR, TV or CD amateur is not interfering.

Attention!

In adverse to “normal” RC5 remotes do I change the toggle bit is not in any keystroke. Anniversary key has a abstracted toggle. This is easier to force the receiver. It is accordingly not possible, the receiver with a RC5 alien ascendancy to use! It is alone with my stations.

For abbreviate distances, the LED anon from R2 (then 150 ohms or greater) to be affiliated and ground. The proposed ability amplifier accepted is of about 100mA. Some of my remotes draft up to 250mA through the LED. For 5V could to access the manual power, a additional LED in alternation with LED1. R1 is again 22 ohms.

Several RC5 Infrared Transmitter Circuit Diagram Schematic

Burning file and source code in C, schematic and board for Eagle3.5

About J0-3, the command cipher to be beatific from 0-15 are set in bifold code. Before anniversary mission, the jumpers are queried. To accelerate the cipher can again restart the PIC’s archetype by an added ambit to be afflicted after it. As a alarm for the PIC actuality I use the centralized RC-oscillator. The is added absolute than I had expected. Between 3V and 5V, it is no botheration with the recipient. At 2.5 V (2xNiCd cell) it works but not always. Even at acute temperatures, there could be problems. There charge be a quartz oscillator to GP4 be affiliated fifth the cardinal of adjustable codes abominably avalanche to four. Antecedent cipher and centralized book I charge for affluent to.

3-channel transmitter (PIC12C508)

Burning file and source code in C, schematic and board for Eagle3.5

The transmitter sends the codes 5,6,7. GP4, 5 are accessible and are not used. Only GP0, 1,3 accept centralized pullups and can deathwatch the PIC from sleep. the oscillator is the aforementioned as for the one-channel transmitter. GP4, 5 but are still free. So no problem.

5-channel transmitter (PIC16F84)

Burning file and source code in C, schematic and board for Eagle3.5

3-channel transmitter (PIC12C508)The transmitter sends the codes 5,6,7. GP4, 5 are accessible and are not used. Only GP0, 1,3 accept centralized pullups and can deathwatch the PIC from sleep. the oscillator is the aforementioned as for the one-channel transmitter. GP4, 5 but are still free. So no problem.

16-channel transmitter (PIC16F84)

Burning file and source code in C, schematic and board for Eagle3.5

This receiver is agnate to one-channel transmitter advised to be, but can be acclimated with the added stations also. It is acceptable back alone a distinct accessory or set to alone one action is to be executed, eg ablaze on / off, axial locking accessible / close. With the jumpers, the codes will be set 0-1.

1-channel receiver with 16 selectable codes (PIC12C508) Circuit Diagram Schematic

Burning book and antecedent cipher in C, schematic and lath unrouted () for Eagle3.5

This receiver can assay channels with codes 0-11 12th For example, switchable ability strips.

As the quotes from various sources and Holger-klabunde.de